Mitra burgija sa dve testere i bušenje

Zotech U2PRW

The U2PRW cutting and drilling machine is designed for processing slats and furniture fronts made of solid wood or MDF. The machine works in a semi-automatic cycle. During one cycle the machine performs: cutting at a given angle (in the range of 45 - 90 degrees) and drilling in the jammed plane, or the edge of the element.


- Made in Poland


TECHNICAL PARAMETERS:
max. height of cut material 60 mm
Gjdeq Ii Dljpfx Afusuk
max. width of cut material at an angle of 45° 70 mm
max. width of the material at an angle of 90° 150 mm
max. length of cut material 2200 mm
min. length of cut material at 45° 455 mm
diameter of main saw 250 or 300 mm
undercutter diameter 100 mm
max. diameter of bottom milling cutter 35 mm
max. depth of bottom milling 15 mm
diameter of face drill embedment and bottom milling cutter 10 mm
Drill head (face drilling):
spindles 4
axial spacing of spindles 32 ; 32 ; 40 mm
linear arrangement of spindles
max. depth of face drilling 60 mm
installed power 7 kW
working pressure 0.6 Mpa
overall dimensions (length / width / height) 4300 / 1600 / 1570 mm


Machining units

The machine is equipped with two machining units. The left unit, which is fixed, and the right unit - a sliding unit. Each machining unit consists of the following sub-assemblies - units: a main saw, an undercutting unit, a drilling unit that drills into the jammed plane, and a drilling unit that drills into the bottom of the workpiece.


Bottom hole drilling unit

The described aggregate is installed as an option. It is used in the processing of corner ties for doorframes with adjustable width. It makes a blind bore , for the can connector. The picture shows the mounted red cover which is at the same time the base for the machined angle strips and the cover with chip extractor.


Workpiece pressure

The machine tool is also equipped with a clamping system operating in two planes. The clamping area includes horizontal and vertical clamps. The horizontal clamps are responsible for pressing against the vertical bases and straightening the workpiece. Vertical ones, on the other hand, are responsible for immobilizing the workpiece during machining. The horizontal pressure always precedes the vertical pressure.


Control

The machine's control is clear, easy to use and functional. It allows switching on or off all aggregates separately, additionally with division into left and right sides. All aggregates have independent drive. The right-hand processing unit is set by pressing the control buttons on the control panel. The executive mechanism is a gearbox with an electric motor driving a trapezoidal screw. An electronic control system US with an operator panel and digital display is used to read and set the length of the workpiece. This system is also responsible for automatic corrections to the counter readings when the cutting angles change by 45° and 90°. In addition, it is responsible for automatic basing.

Oglas je automatski preveden. Moguće su greške u prijevodu.